Mobile Crossing WayPoint Map Loader Návod k obsluze Strana 26

  • Stažení
  • Přidat do mých příruček
  • Tisk
  • Strana
    / 130
  • Tabulka s obsahem
  • KNIHY
  • Hodnocené. / 5. Na základě hodnocení zákazníků
Zobrazit stránku 25
The versions of this program before 5.0 only used calculation method 3. Examine the government (DMA) tables for
your area and see if all of the ASF factors are more or less the same over the area. This technique does very well in
some areas and insures that even waypoints far from the calibration waypoints are adjusted. If the ASFs vary
considerably over the coverage area, then consider splitting up your files to cover smaller areas that can have the same
ASF over that area.
The Calibration selection screen has a button that allows you to examine the ASFs of both the government and user
calibrated tables for your area. This will better inform you as to the ASF values that will be used and to give you a feel
for the variability of the values over your area. In some areas, the ASF values are very uniform across the area and a
single value will be a good choice. In other areas, the ASF values vary widely from place to place and you will be much
better off using the calibrated tables. The example below shows one such area where the values are not uniformly
distributed. The tables are in 5-minute increments (5 minutes is about 5 nautical miles). This table shows a jump from
0.47 to 0.56 microseconds in just 5 miles. That’s a potential error of over 100-ft if the same ASF is used for both areas.
Zobrazit stránku 25
1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 129 130

Komentáře k této Příručce

Žádné komentáře